How to Install Power Steering Hose

Power Steering Hose on Engine Bay

Steering wheel has a powerhouse at the back end which helps function it well. This powerhouse is a power steering hose, which contains steering fluid. This fluid permits the smooth movement of steering wheel and makes it turn easily.

Without it, turning wheel of your vehicle will not work. Like every other car part, steering hose deteriorate over time. It becomes inactive and ineffective because of rust and dust. Problem in turning of steering wheel is always tracked back to power steering hose. You can now replace damaged hose all by yourself. Read the following article so you can perform it step by step.

Step 1 – Buy New Hose

Power steering hose is an important hose and is fabricated for different makes and models. You can purchase it easily as it is available on all local auto parts stores. Go to a local dealer with specifications of your make and model, he will help you find the perfect match for your ride. You should also be aware of tips that are needed to buy steering system components.

Power Steering Hose Pipe

Step 2 – Identify Power Steering Hose

As there are different components under the hood, you will need car’s manual to find out the exact location of steering box. In most cars it is placed close to fender, mostly on left side inside the engine bay. You can recognize it by several threaded fittings and dark colored. It is braided and not smooth.

Step 3 – Remove Hose

You will need a drain pan in this step to collect steering fluid that might pour from hose. There are different bolts that connect this hose to valves, you should turn nut with the help of wrench. It is to be turned left in order to loosen it.

Because of excessive oil and gunk, nut gets frozen and gives hard time in turning. Use rag to wipe it down. You can also use a lubricant to get the work done. Pull out the hose off valve and slowly plug it with rag.

Step 4 – Install New Hose

Finally wipe down the valves so you can eliminate dirt and oil. Place one end of hose to valve and start tightening it by using wrench. It should be done by slowly turning it in right direction. Repeat it with other end of hose and tighten different bolts, clamps, and shields that were removed before.

Keep filling power steering reservoir with steering fluid and don’t stop until it has reached the cold level. Switch on engine to check the functioning of newly installed hose. Turn wheels frequently so it bleeds steering hose of air. Check out for any leaks while the car runs and then fill the reservoir. Renew the cap, close the hood and you are all set to go. You can also purchase new hose from our online auto parts superstore.

Leave a Reply

Your email address will not be published. Required fields are marked *