4 Simple Steps Tighten Brake Fittings

Tighten Brake Fittings

For an efficient and high performing braking system, brake fittings should be tight. If you are tightening these fittings in your car, check all those components that combine to make brake system. Start with removing debris, grease, and dirt, as they are harmful for car parts. Do not let brake pads encounter engine oil and grease. Before starting, you need to gather following tools in working area.

Pair of pliers

Jack Stand

Line Wrench

Axle Stand

  1. Secure Vehicle:

Keep the car supported and chock its wheel as a safety measure. Loosen small nuts and bolts of wheels with the help of pliers. Open up bonnet, find brake master cylinder reservoir cap and start loosening it. Get a jack and raise your vehicle to an accessible level. For extra support, make use of axle stands. Once it is all done, remove road wheel too.

  1. Check Wheel

Examine wheel to see if it is balanced. There should not be any lateral run out as rims and lateral must run along. Make use of pliers for tightening to recommended torque Sand keep its motion clockwise.

  1. Calipers

Calipers should be free from wear and tear and if they are already damaged, make the replacement for improvement in brake system’s effectiveness. You can purchase them from our online auto parts superstore. Also check piston to ensure that they move without obstruction. At this step, you should also tighten other guide elements like channels, bolts, and bushings with the help of pipe wrench. You can also use a pair of pliers to do the work. Efficiency of system is compromised if they are set loose. Replace brake pads with new one if they are damaged and old.

  1. Brake Discs

Remove dirt and grease from brake discs and clean them with soapy rag. If discs are severely damaged, replace them with new one. You can purchase these new discs from our online auto parts superstore. Position brake discs centrally with the help of balancing clamp disc brakes. Keep the movements balance as they should not be over tightened.

Next look for steering bushes and examine their condition. If they are damaged or just too soft, you should make an immediate replacement. While checking wheel suspension, verify the condition of spring strut and shock absorber too. Make replacements if necessary. In the end, make final replacements of wheel bearings, steering gear, steering damper and suspension joints if required. All these measures will enhance the efficiency of your car’s braking system.

Leave a Reply

Your email address will not be published. Required fields are marked *